Auto Mate 5104A Manuál s instrukcemi stáhnout pdf (Strana 18)

Emergency Override

The following procedure disarms the system when a programmed re-

mote is not available. Number of presses__________

1. Turn the ignition On.

2. Press the control button on the Control Center the correct

number of times (the default is 1 press).

3. After a few seconds the siren output ceases and the system

is disarmed.

Note

As a precaution, if programmed for Passive Arming or Auto

re-arming the system should be placed into Valet Mode until

a remote is available .

Trigger Zone Fault Report

When armed by remote command the system runs a status check of

the alarm trigger zones. Faulty zones (usually caused by dome light

delay or open trunk) are bypassed and reported via the control center

LED, while all other trigger zones remain active and are monitored to

protect the vehicle. Should a faulty zone self correct (dome light turns

off) it becomes active and is then monitored normally.

The siren chirps once again a few seconds following the arming

chirps as an audible alert, the control center LED ﬂashes in groups to

indicate the zone number.

Alarm Report

If the alarm was triggered while armed, it will be reported when

the alarm is disarmed via siren chirps, parking light and control center

LED ﬂashes. The siren chirps 4 times (or 5 times if NPC On*), the park-

ing lights ﬂash 3 times, and the control center LED ﬂashes in groups to

indicate the last two zones that were triggered (see Table of Zones).

The report output will repeat for each disarm operation until the igni-

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

Žádné komentáře

Auto Mate 5104A Manuál s instrukcemi Strana 18